這幾日的progress:

1.上了conductive paint

2.修整了不夠位的地位，route 多少少邊

3.裝了tone, volume pot, LED, 3pdt switch

4.裝了pickup...用了兩隻yamaha cheap single coil 打孖上，無mud 特別，致在夠型...

Pocket Pod in guitar pocket---ultimate guitar for practise

Line 6 的 Pocket Pod 已經出了一段時間，到近期先忽發奇想有這個idea...

之前有諗過將自己部Korg Px5d 放入支結他，因為自己很懶，心想如果成功放部機入結他，練結他時只需用headphone就搞掂，又可以line-in 部MP3 jam 歌，不過Korg 部機d control 實在太複雜，打消了念頭..

後來比我諗起line 6 部Pocket POd，剛剛Tom lee 又做緊特價，$699 有部，而且個size 又ok，於是買黎進行這個project...

一開始計劃的時候就想到一個很大的問題：電力。嘗試開著部機玩，4舊AAA 電(6V)用唔夠3個鐘就玩完，點算？如果要長時間練歌或出show，突然無電係好大問題，用乾電好唔環保，但用濕電0下0下都要用火牛........諗來諗去終於比我諗到用搖控車電池，咁arm 有一排5舊的電池，又係6V，有成5000mA，估計應該可以用成日！

今日route 了電池及Pod PCB 的cavity，下一部要上conductive paint 做shielding，install 多一個電力開關及bypass switch，等我可以有時bypass 個effect，淨係出clean signal 出amp..

最近替一支classical guitar 做partial re-fret，本身的fret 在fret end 嚴重leveled down 了，要換過兩條新fret. 工序比想像中complicated，由於前後fret 的高度也不平均，要慢慢逐part 逐part 慢慢磨，就返前後fret 的高度，整完之後又發覺12格以上low -E 線的fret 有buzz，就順手level 埋12格以上 1,2線的fret top，總算修復了問題。

Dyed tele body and oil finished with Tru-oil

Dyed with a mixture of cherry red and walnut brown.....the colour turned out to be quite reddish than I expected...um......

However, the wood grain pop up when I applied the Tru-oil, which darkens the colour a bit more, making it more brownish.....good!

Glockenklang preamp installation

OLP axis restoration

working on Keivn's OLP axis, the cracked part is carefully knocked off, leaving the lacquer surface intact, did a bit touch up along the cracked line ,then clamp it on both sides.
coming up next is the repair of the crack on the surface, plus re-polishing the top

Lindy Fralin high output hum set....

Attention to all: I will be very busy in the rest of July and I should be able to resume repair and maintenance at the beginning of Augest, thanks for all of you who trust me and supported my work!